Table of Contents
Advertisement
en Home Connect
Notes
¡ Please note the safety precautions in this instruction
manual and make sure that they are also observed
when operating the appliance via the Home Con-
nect app.
→ "Safety", Page 2
¡ Operating the appliance on the appliance itself al-
ways takes priority. During this time it is not possible
to operate the appliance using the Home Connect
app.
¡ In networked standby mode, the appliance requires
a maximum of 2 W.
16.1 Setting up Home Connect
Requirements
¡ The appliance is connected to the power supply and
is switched on.
¡ You have a mobile device with a current version of
the iOS or Android operating system, e.g. a smart-
phone.
¡ The mobile device and the appliance are within
range of your home network's Wi-Fi signal.
16.2 Home Connect Settings
You can adjust the settings and network settings for Home Connect by going to your appliance's basic settings.
Which settings the display shows will depend on whether Home Connect has been set up and whether the appliance
is connected to your home network.
Basic setting
Wi-Fi
Network
Connect to app
Remote control
Appliance information
16.3 Operating the appliance with the
Home Connect app
When the Remote start function is activated, you can
use the Home Connect app to remotely configure the
appliance's settings and start it.
Note: Some operating modes can only be started on
the oven itself.
22
Possible settings
Switch on
Switch off
Connect to network
Disconnect from network
-
On
Off
-
Download the Home Connect app.
1.
Open the Home Connect app and scan the follow-
2.
ing QR code.
Follow the instructions in the Home Connect app.
3.
Explanation
If Wi-Fi is activated, you can use Home Connect.
In networked standby mode, the appliance requires a max-
imum of 2 W.
If you disconnect the appliance from the network, all network
information will be deleted. This setting is useful if you have
new login details for the router.
This setting initiates the connection between the Home Con-
nect app and the appliance.
When this function is deactivated, all you can do is view the
appliance's operating status in the app.
When this function is activated, you can remotely start and
control the appliance.
The display shows information about the network or the appli-
ance.
Requirements
¡ The appliance must be switched on.
¡ The appliance must be connected to your home net-
work and to the Home Connect app.
¡ To configure the appliance's settings using the
Home Connect app, "Remote control" must be
switched on in the basic settings. When the Remote
start function is deactivated, only the appliance's op-
erating statuses are displayed in the Home Con-
nect app.
Tap
.
1.
Tap "Remote start".
2.
a The display will show .
Configure a setting in the Home Connect app and
3.
send it to the appliance.
Advertisement
Table of Contents
