Preparations For Electrotherapy - Mettler Electronics Sonicator Plus 941 Instruction Manual

Preparations for Electrotherapy

● Using the Self-adhesive Electrode
1
Connect the electrode cable to the Self-adhesive Electrode.
Insert the connection pins of the electrode cable
into the cord for the corresponding parts of the
Self-adhesive Electrode.
* The electrode cable has two connection pins. Be
sure to connect the two corresponding parts of the
Self-adhesive Electrode to the two pins.
* While the tips of the two electrode cables are black
and gray, the pins can be interchangeably connected
with the two parts of the Self-adhesive Electrode.
2
Apply the two parts of the Self-adhesive Electrode securely
to the treatment area.
* If the two parts of the Self-adhesive Electrode are
not securely applied when treatment (output) starts,
an error will result.
3
Connect the connector for the electrode cable to the
electrode cable connection port on the Main Unit.
4
When the power switch is turned on, an icon
How to peel Self-adhesive Electrode
To peel the Self-adhesive Electrode from
the transparent film or skin, hold a corner
of the pad and lift slowly. Do not pull the
cord to peel.
Insert each pin fully until you can
no longer see the metal portion.
appears.
(Correct) (Incorrect)