Hunter Crestfield Installation Manual page 7

Prep
Installation
– Fan Body, Wiring Harness, Canopy Cover, and Blades
Connect
2a
Complete
2b
2c
2a
A
B
1
NOTICE
To prevent damage to fan, ALWAYS lift holding either the fan housing or
the downrod. Do not lift by wires.
Install snap-on canopy (B) over downrod on fan body (C). Place the down
rod ball into the slot in canopy mount (A) with built-in ceiling bracket.
Rotate the downrod into an
upright position.
Keep downrod upright and
lower downrod adapter cover
and twist clockwise until tight.
B
C
2d
2b
A
Note: For single switch wiring an additional
jumper harness component will be needed.
B
Take the jumper harness (H) from the
accessories bag. Connect the female end
to the hanging bracket connector. Connect
C
the male end of the jumper harness to the
ceiling fan connector.
Connect wiring harness from canopy mount (A) to wiring harness
from fan body (C).
2e
B
Slide the snap-on canopy (B)
over the canopy mount (A)
until it clicks in place.
2f
2d
x5
E
2
Install a snap-on blade to pop locks on pre-installed
blade iron.Repeat for remaining blades (E).
H
I
IMPORTANT
C
Note:
Fan style may vary.
7