Hunter Crestfield Installation Manual page 12

If you need a different downrod length follow these steps:
1
In order to change the length of
downrod, the pivot assembly needs to be
disengaged. Rotate the downrod into an
upright position.
5
5
Slide down inner sleeve (5).
9
12
Reinstall small metal pin (10)
and ground screw (11). Slide
ball up (12).
13
Keep downrod upright and lower
downrod adapter cover and
twist clockwise until tight.
Using a Different Size Downrod
2
Cross Pin
Retention
Spring
Disengage retention spring by
pulling away from rod. Then
remove cross pin from downrod.
Remove downrod assembly
from pivot assembly.
6
6
Remove ball, inner sleeve,
downrod (6), and adapter cover.
10
1 3
Reinstall ball screw (13).
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS follow the downrod assembly
instructions exactly.
• VERIFY the downrod is assembled correctly
by firmly pulling on the hanger ball.
3
1
Remove ball screw (1).
7
7
8
10
Route ground wire and wiring
harness through accessory
downrod–12" max. (7). Slide
adapter cover, inner sleeve and
ball over downrod (8).
11
Pivot
Bracket
Place downrod assembly
between the pivot bracket and
make sure holes are aligned.
4
2
Slide ball down (2), remove
small metal pin (3) and ground
screw (4).
8
9
Slide up inner sleeve (9).
12
Cross Pin
Retention
Spring
Push the retention spring to
the side to allow cross pin
access. Place cross pin through
downrod assembly and the pivot
bracket. Place retention spring
into the groove of the cross pin.
Note:
Fan style may vary.