Supermicro H12SSW-iN User Manual page 43

Chassis Intrusion (JL1)
A Chassis Intrusion header is located at JL1 on the motherboard. Attach the appropriate cable
from the chassis to the header to inform you when the chassis is opened.
Overheat LED/Fan Fail (JOH1)
The JOH1 header is used to connect an LED indicator to provide warnings of chassis
overheating or fan failure. This LED will blink when a fan failure occurs. Refer to the table
on right for pin definitions.
Overheat / Fan Fail
Pin Definitions
Pins Definition
1 5vDC
2 OH Active
IPMB System Management Bus Header (JIPMB1)
A System Management Bus header for IPMI 2.0 is located at JIPMB1. Connect the appropriate
cable here to use the IPMB I
Chassis Intrusion
Pin Definitions
Pins Definition
1 Ground
2 Intrusion Input
C connection on your system.
2
IPMB Header
Pin Definitions
Pin# Definition
1 Data
2 Ground
3 Clock
4 No Connection
43
Chapter 2: Installation
Overheat / Fan Fail
LED Status
Status Definition
Off Normal
On, Solid Overheat
On, Blinking Fan Failure