Lamp Replacement; Resetting The Lamplife Time - Philips LC313199 User Manual

Lamp replacement

B
B
A
Resetting the lamplife
AV
AV
Source Source Menu Menu
Mute
Mute
Lamp Lamp
Stand Stand
by by
Temp Temp
Philips Multimedia Projector
6. Maintenance
5 Unscrew screw B.
6 Grasp the lamp holder handle and carefully pull the lamp holder out of the projector.
• Do not tilt. If the inner tube is broken glass particles may fall out.
• Keep lamp holder opening to your right. Do not touch lamp or point lamp holder opening
at anyone.
7 Carefully remove the new lamp housing from its package.
• Always use the same type of lamp: See 'Optional accessories' for the correct type of lamp
for your projector.
• Do not touch lamp or point lamp housing opening at anyone.
• Do not drop, as the impact may cause the lamp to break.
8 Place the lamp holder in the guiding slots and insert into the lamp compartment.
9 Tighten screw B again.
10 Put the lamp door back in place and press tab A back in its original position.
– The Mains inlet socket will open again.
11 Insert the mains lead into both the projector Mains inlet socket and the wall socket.
12 Press the Standby button to switch on the projector.
13 Reset the lamp life time (see 'Resetting the lamplife time').
14 Dispose of the old lamp in special chemical disposal bins.
1 Press Menu.
time
– The menu bar appears on the screen.
OK OK
2 Use cursor control to select 'Settings' in the menu bar.
3 Use cursor control to select 'Lamp counter' in the sub menu.
4 Press OK for 3 seconds to reset the lamp counter.
5 If required, select another item you wish to adjust or press Menu to exit.
30
English User guide bSure1 / bSure 2
<