Adjusting The Focus And Size Of The Image; Adjusting The Vertical Angle Of The Projector; Keystone Correction; Moving/Transporting The Projector - Philips LC313199 User Manual

Adjusting the focus and
size of the image
Zoom ring
Focus ring
Adjusting the vertical angle
of the projector
A
B

Keystone correction

Moving/transporting the
projector
Inserting the batteries in
the remote control
Philips Multimedia Projector
3. Set up
• Use the Zoom ring to adjust the size of the image.
• Use the Focus ring to adjust the focus of the image.
To raise:
• Keep knob A pressed and lift to raise the projector.
– The Height/Level Adjuster B will come out.
To Lower:
• Keep knob A pressed and gently lower the projector.
• Use the Focus Ring and Zoom Ring to readjust the focus and size of the image.
If projector and screen are not properly placed, the picture will be distorted, producing a
keystoned image (picture top width larger than picture bottom width or vice versa). When a
keystoned image occurs the 4:3 ratio will still be guaranteed.This is especially important when
the projector is being used together with an 'intelligent whiteboard'.
'Keystone correction' allows you to correct picture distortion of the vertical keystone type by
internal scaling.This correction function is accessible through the 'Keystone Correction' option in
the 'Settings' menu of the On Screen Display (OSD) menu.

Preparation

1 Press the Standby button twice to put the projector in Power/Standby.
– The Standby indicator starts blinking orange.
2 Wait until the cooling fan has stopped (about 3 minutes after the projector has been put in
Standby) and disconnect the mains lead and all other cables.
3 Put the lens cap back in place to prevent dust, dirt or other contamination from harming or
damaging the front of the projector lens when moving the projector.
Note
Never place the projector on the side where the connections are located.

Moving/transporting the projector

The projector contains many glass and precision parts. If you need to transport the projector,
please follow these packing instructions to pervent accidental damage to the projector.
• When you are hand-carrying the projector, be sure to use a carrying case like the optional
softbag.
• When shipping the projector, use the original packaging material if possible. If you do not
have the original packaging, use equivalent materials, placing plenty of cushioning around the
projector.
• When transporting the projector as freight or checked luggage, first put it in a carrying case,
then pack it in a firm box, using cushioning around the case.
1 Push and slide the lid in the direction of the arrow.
2 Install two 'AAA' batteries as indicated inside the battery compartment.
3 Replace the lid and snap it into place.
Note
The maximum range of the remote control is approximately 15 m (± 50 feet).
11
English User guide bSure1 / bSure 2
>