Resetting The Projector; On Screen Display Menu - Philips LC313199 User Manual

AV AV
Source Source Menu Menu
Mute Mute
Lamp Lamp
Stand Stand
by
by
Temp
Temp
Philips Multimedia Projector
5. Operation

Resetting the projector

1 Press the Standby button twice in succession to switch the projector into the Power/Standby
mode.
OK OK
2 Wait until the cooling fan has stopped (about 3 minutes after the projector has been
switched to Power/Standby).Then disconnect the mains lead to switch off the mains supply.
3 Connect the mains lead again and press the Standby button to switch the projector back
into Power/Standby mode.
– The Standby indicator lights up red, the projector is now in the Power/Standby mode.
4 Press any button on projector or remote control to switch on the projector.
– The Standby indicator lights up orange.
– When the projection lamp is on, the Standby indicator lights up green and your personal
start-up screen appears.
Note
Your personal start-up screen will appear each time the projector is switched on exept when the
SecurityMax™ application has been activated.The SecurityMax™ start-up screen will then appear.
27
On Screen Display Menu <
English User guide bSure1 / bSure 2