Table of Contents
Advertisement
Functional details
Safety shutdown
If the high-pressure cleaner is accidentally not turned off after use or the safety
trigger gun is not used for 20 minutes, the high-pressure cleaner automatically
changes into safety state by deactivation. By operating the main switch once
more, the high-pressure cleaner is activated again.
High-pressure hose and spray device
The high-pressure hose and spray device which are part of large quadro series
equipment, are made of high quality material and engineered to conform with
the operating conditions of the high-pressure cleaner and are duly labeled.
If replacement parts are required, only such parts that are authorized
by the manufacturer may be used. The warranty is automatically void if
spare parts of third-party providers are used! The high-pressure hose and
spray device must be connected in a pressure-tight manner
(without leakage).
The high-pressure hose may not be driven over, pulled excessively, or
twisted. The high-pressure hose may under no circumstances be pulled
over sharp edges. Defective high-pressure hoses must not be repaired
(acc. to DIN 20022) but have to be replaced by new hoses approved by
the manufacturer.
Prior to putting the high-pressure cleaner into operation make sure
that all safety instructions be observed.
20
Putting into operation
Neither set up or operate the large quadro series in rooms where there
is a risk of fire or explosion nor put it into puddles. Do not use the high-
pressure cleaner under water. If, none the less, the high-pressure
cleaner is operated in a hazardous area, the applicable safety
regulations are to be observed.
1.
For high-pressure cleaners with hose
drum the enclosed hand crank mus be
applied prior to first operation.
Plug the hand crank onto the hexagon
and attach it with the enclosed screw
and washer.
2.
For moving the high-pressure cleaner
to the place of use, please release
locking break.
3.
The large quadro series is a movable
high-pressure cleaner with sturdy trol-
leys ideally suited for difficult terrain.
For steering the high-pressure cleaner
put the foot against the tipping
support and then pull the device
towards you.
4.
For transport purposes the handle
can be taken off easily. First detach
the high-pressure hose from the hose
drum. After that, unscrew the fixing
screws and detach handle and hose
drum
21
Advertisement
Table of Contents
