Volvo V90 Owner's Manual page 492

STARTING AND DRIVING
®
15
HomeLink
*
®16
HomeLink is a programmable remote con-
trol, integrated in the car's electrical system,
which can remotely control up to three differ-
ent devices (e.g. garage door opener, alarm
system, outdoor and indoor lighting) and
thereby replace the remote controls for them.
General
The figure is schematic - the version may vary.
Button 1
Button 2
Button 3
Indicator lamp
Applies to certain markets.
15
16 HomeLink and the HomeLink house symbol are registered trademarks of Gentex Corporation.
17 Note that the toll-free number may not be available depending on operator.
18 Applies to certain markets.
490
®
HomeLink is supplied built-in to the interior
rearview mirror. The HomeLink
sists of three programmable buttons and one
indicator lamp in the mirror glass.
For more information about HomeLink
www.HomeLink.com or call
00 8000 466 354 65 (or the toll number
+49 6838 907 277) 17 .
Save the original remote controls for future
programming (e.g. when changing to another
car or for use in another vehicle). It is also rec-
ommended that the programming for the but-
tons is deleted when the car is sold.
Related information
®
• Using HomeLink * (p. 492)
®
• Programming HomeLink * (p. 490)
• Type approval for HomeLink
Programming HomeLink
®
panel con-
Follow these instructions to program
HomeLink
gram individual buttons.
®
, visit
NOTE
In certain vehicles the ignition must be
switched on or in "accessory position"
before HomeLink
used. If possible, fit new batteries in the
remote control that shall be replaced by
HomeLink
improved transmission of the radio signal.
The HomeLink
before programming.
WARNING
While programming HomeLink
®
* (p. 493)
garage door or gate being programmed
may activate. For this reason, make sure
that nobody is in the vicinity of the door or
gate while programming is in progress. The
car should be outside the garage while a
garage door opener is being programmed.
®
18
*
®
, reset all programming or repro-
®
can be programmed or
®
for faster programming and
®
buttons should be reset
®
, the
* Option/accessory.