System-Board Shield; Removing The System-Board Shield - Dell OptiPlex All-in-One Plus 7410 Owner's Manual

5. Align the screw holes on the graphics card with the screw holes on the graphics-card assembly.
6. Loosen the four captive screws that secure the graphics card to the graphics-card assembly.
7. Replace the two screws (M2.5x5) that secure the graphics card to the graphics-card assembly.
8. Flip over the graphics-card assembly.
9. Connect the graphics-card fan to the graphics card.
10. Close the DGFX door and press it into place, securing it.
11. Place the graphics-card assembly on the display-assembly base and slide the graphics card into the PCIe x16 connector
(SLOT1 PCIe4 x4) on the system board.
12. Replace the two screws (M3x5) that secure the graphics-card assembly to the display-assembly base.
Next steps
1. Install the back cover.
2. Install the stand.
3. Follow the procedure in

System-board shield

Removing the system-board shield

Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the back cover.
About this task
The following image(s) indicate the location of the system-board shield and provides a visual representation of the removal
procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs) 49