Installing The Stand - Dell OptiPlex All-in-One Plus 7410 Owner's Manual

Steps
1. Place the display-assembly base on a clean and flat surface.
2. Press and hold down on the tab that secures the stand to the display-assembly base.
3. Slide and lift the stand off the display-assembly base.

Installing the stand

Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: Depending on the stand you are installing onto your computer, refer to the corresponding image shown in the
procedure.
The following image(s) indicate the location of the stand and provides a visual representation of the installation procedure.
Removing and installing Customer Replaceable Units (CRUs) 39