Table of Contents
Advertisement
To stop operation
Push I/O button
All settings will be stored when you power the system on later.
To change temperature setting:
Push + button to increase the temperature. The setting will be increased by 1°C/°F each time when you press the
button.
Push - button to decrease the temperature. The setting will be decreased by 1°C/°F each time when you press
the button once.
Heating operation:
The machine will overload if the air conditioner becomes too hot. The fan of the outdoor unit will stop automatically. It is
not a failure if the outdoor unit frosts when the fan stops.
Dehumidification operation:
The temperature is preset, and cannot be adjusted. The system will run at a temperature slightly lower than the room's
ambient temperature. The fan will run at low speed and cannot be adjusted while in dehumidification mode.
Emergency Operation
If the remote controller is lost or broken, you can use the emergency operation switch found on the Indoor Unit. When you
push the button, emergency operation is selected.
YMGI: Your Modern Green Idea
Automatic Operation:
A comfortable room temperature will be reached automatically and economically as the
preset control system will adjust the operation mode in accordance with the real room
conditions.
You can select your desired temperature, fan speed, and fan direction by using the
remote control's buttons.
To protect the compressor, the automatic time-lapse protection is possessed. If the
compressor stops running, you will need to wait at least 3 minutes before restarting.
When the outdoor temperature is very low, the Outdoor Unit's heat exchanger is susceptible
to frosting. This may affect heating performance. If the LED indicator flashes, and the Indoor
Unit fan motor stops, it has entered defrost mode. Once the unit has defrosted, it will resume
normal heating operation automatically.
Manual Control
Using Manual Control for cooling, dehumidification of heating operation:
Push I/O button.
Select the operation mode
Push MODE to select operation mode.
The operating mode sequence is:
Automatic → Cooling → Dehumidification → Heating
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
Push once
52
Advertisement
Table of Contents
