Table of Contents
Advertisement
Gas Conversion (ULPG to NG)
If the required gas conversion kit is not supplied with your
appliance, contact Technika. Gas Conversion shall only be
undertaken by authorised persons.
The ULPG to NG conversion kit contains...
- NG Regulator
- Auxiliary Jet Ø090mm
- Rapid Jet Ø1.55mm
Converting to a different gas type
When converting from ULPG to Natural Gas ensure that the ULPG
test point is removed and replaced with the AGA Approved NG
Regulator supplied in this kit. The test point pressure must be
adjusted to 1.00kPa with the largest burner
operating on maximum flame.
Changing the jets
1. Remove pan supports, burner heads and caps.
2. Use a size 7 socket wrench to unscrew and
remove the jets, replacing them with those
supplied in this kit. Ensure you use the correct
jet for the corresponding burner.
3. Reassemble the burner heads, caps and pan
supports.
4. Fit the Gas type label supplied with this kit next
to the gas connection point and remove the
existing label.
Setting the minimum level
1. Light one of the burners and turn the tap to
minimum flame.
2. Remove the corresponding control knob.
3. Use a thin blade screwdriver to turn the by-pass
screw located in the brass shaft as shown right.
Turn the by-pass screw fully clockwise then turn
it anti-clockwise 1/4 turn for the Wok and 1/8
turn for all other burners. The result should be a
small, stable flame which is uniform around the
entire burner ring. If not, turn the by-pass screw
anti-clockwise until satisfied with the flame.
4. Check that the burner does not go out when the
tap is turned quickly from the maximum to the
minimum position.
5. Repeat for each burner.
- NG
Gas Type label
- Semi-Rapid Jet Ø1.18mm
- Wok Jet Ø1.70mm
20
Advertisement
Table of Contents
