Cleaning The Cab Condenser Filter; Replacing The Dome Light - Toro 31902 Operator's Manual

Figure 83
1. Filter
2. Knob
2. Remove the air filters from the cab.
3. Clean the filters by blowing clean, oil-free,
compressed air through them.
Important:
If either filter has a hole, tear, or
other damage, replace the filter.
4. Use the knobs and grates to install the filters
into the cab (Figure
Cleaning the Cab
Condenser Filter
The purpose of the cab condenser filter is to prevent
large debris, such as grass and leaves, from entering
the cab condenser and condenser fans.
1. Pull the screen cover straight down.
2. Clean the condenser filter with water.
Note:
Do not use a pressure washer.
Important:
If the filter has a hole, tear, or
other damage, replace the filter.
3. Allow the filter to dry before installing it into the
machine.
4. Rotate the filter screen around the tabs until
the latch locks into the latch-mount assembly
(Figure 84).
3. Grate
83).
1. Latch-mount assembly
g251432
2. Condenser filter

Replacing the Dome Light

Note:
Refer to the Parts Catalog for the appropriate
bulb part number.
1. Use a screwdriver to remove the light lens from
the control panel.
1. Screwdriver
2. Bulb
2. Remove the bulb from the light base
3. Install a new bulb into the light base.
4. Install the lens into the control panel.
68
Figure 84
3. Screen cover
(Figure 85).
Figure 85
3. Lens
(Figure
g032951
g253616
85).