Table of Contents
Advertisement
8. The Console (21) can use two AA batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together. IMPORTANT: If the Console has
been exposed to cold temperatures, allow
it to warm to room temperature before you
insert batteries. Otherwise, you may damage
the Console or other electronic components.
Remove the battery cover from the back of the
Console (21), and insert batteries into the battery
compartment. Make sure to orient the bat-
teries as shown by the diagram inside the
battery compartment. Then, reattach the bat-
tery cover.
9. While a second person holds the Console
(21) near the Frame (2), connect the wire on
the Console to the Frame Wire (11). Insert the
excess wire into the Frame.
Tip: Avoid pinching the wires. Attach the
Console (21) to the Frame (2) with four
M4 x 16mm Screws (22); start all the Screws,
and then tighten them.
10. Make sure that all parts are properly tightened before you use the rower. Extra parts may be included.
Place a mat under the rower to protect the floor.
8
21
9
21
10
Battery
Compartment
2
11
22
Avoid pinching
the wires
Advertisement
Table of Contents
