Ferroli SKY ECO F Series Instructions For Use, Installation & Maintenance
Hide thumbs
Also See for SKY ECO F Series:
Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ferroli SKY ECO F Series
Summary of Contents for Ferroli SKY ECO F Series
- Page 1 SKY ECO F BAJAS EMISIONES Basso NOx Bajo NOx Emisii reduse de NOx Niska emisja NOx Low NOx ISTRUZIONI PER L'USO, L'INSTALLAZIONE E LA MANUTENZIONE INSTRUCCIÓN DE USO, INSTALACIÓN Y MANTENIMIENTO INSTRUCTIONS FOR USE, INSTALLATION AND MAINTENANCE...
- Page 2 SKY ECO F Read the warnings contained in this In the event of a malfunction or impro- manual carefully. per operation, unplug the unit and have Once the unit is installed, describe its contact registered technicians. The unit operation to the user and give them must only be repaired, and its compo- this manual.
- Page 3 SKY ECO F product. Such representations may in- APPLIANCE INTENDED FOR DOME- STIC USE; NOT VALID FOR INDU- with respect to the product supplied. cod. 3541S170 - Rev. 00 - 02/2019...
- Page 4 SKY ECO F 1 USER'S MANUAL Plug the unit into the mains. Press the ON/OFF key on the control panel for 1 The new SKY ECO F is an instantaneous, high- second. performance, low-emission heater for domestic hot water production, powered by natural gas or LPG and equipped with a compact, burner, chamber, MODULATING fan, and control system with...
- Page 5 SKY ECO F Maximum temperature INSTALLATION MANUAL The combustion circuit is sealed off from the installation environment, so the unit can be installed in any room. Minimum distances ventilated to avoid hazardous situations in the event of On each >2cm >50cm a gas leak.
- Page 6 SKY ECO F SKY ECO F 11 Qnw(DHW)(Hi) 21.7 19.5 10.0 6 (< 56 mg/kWh) 0085 8 430709 513853 1910G80002 40 W IPX4D Ø 3/4” Rating label Assembly template 5 - Remove the unit from the packaging. 7 - Remove the plugs from the water and gas connec- tions (see Fig.
- Page 7 SKY ECO F The pipe must comply with applicable regulations. Avoid areas with heat emissions. Prevent the pipe from bending or being pinched shut. The connections on both sides (gas valve and other components) must comply with the regulations of the country where the heater is installed.
- Page 8 SKY ECO F to be used and make sure it does not exceed the maxi- sate collection (010023X0). mum permitted length by making a simple calculation: accessories and outlet terminals. 2. See Table 1 and determine the losses in meq (equi- valent meters) for each component, depending on its assembly position.
- Page 9 SKY ECO F For the coaxial connection, install one of the following IMPORTANT - THE ROOM MUST initial accessories on the unit. For drilling dimensions on the wall, see section 4.1. Horizontal exhaust segments must slope slightly toward the outside to prevent any condensation from returning to the unit.
- Page 10 SKY ECO F ADJUSTMENTS Carefully verify the tightness of the gas installation using a soap and water solution to check for leaks in the connections. Fill the hydraulic system and make sure no air is present in the unit or system. Check that there are no water leaks in the system or unit.
- Page 11 SKY ECO F FAULTS The heater is equipped with an advanced self-diagnostic system. If a problem arises with the unit, the fault symbol displayed. operation. To restore operation, simply press the RESET key (4 - 3 Lift the casing. must be resolved. that are automatically resolved when the value returns to the heater's normal operating range.
- Page 12 SKY ECO F LIST OF FAULTS Fault Fault Solution Lack of gas no air is present in the pipes. Make sure the electrode is properly installed, Faulty detection/ignition electrode The burner does not connected, and free of deposits. ignite. Faulty gas valve Check the gas valve and replace if necessary.
- Page 13 SKY ECO F 4 TECHNICAL DATA AND CHARACTERISTICS 2 16 Overview 10 Flue gas outlet collector Cold water inlet 11 Flow switch 3 Sealed chamber 4 Domestic hot water outlet 13 Ignition and detection elec- 5 Fan trode 6 Combustion chamber 14 Exhaust diaphragm 7 Burner assembly 15 Double sensor...
- Page 14 SKY ECO F Hydraulic circuit 9 Combustion gas collector Cold water inlet 10 Flue gas outlet collector 3 Domestic hot water outlet 11 Flow switch 4 Sealed chamber 5 Fan 15 Double sensor 7 Burner assembly 8 Copper exchanger cod. 3541S170 - Rev. 00 - 02/2019...
- Page 15 SKY ECO F Data Units Maximum heat capacity 21.7 32.9 Minimum heat capacity 10.3 Maximum heat capacity 19.5 24.2 Minimum heat capacity Performance at max. power 89.9 90.0 90.0 no. x Ø 24 x 0,85 28 x 0,85 32 x 0,85 Ø...
- Page 16 SKY ECO F ErP product fiche MODEL: SKY ECO F 11 Trademark: FERROLI Type: Conventional water heater Symbol Unit Value Item Declared load profile Water heating energy efficiency class (from A+ to F) Daily electricity consumption Qelec 0,083 Annual electricity consumption...
- Page 17 SKY ECO F 5 Fan power supply 11 Flow switch 13 Ignition and detection electrode 17 Hall sensor cod. 3541S170 - Rev. 00 - 02/2019...
- Page 18 FERROLI ESPAÑA, S.L.U. Pol.Ind.Villayuda C/Alcalde Martín Cobos, 4 09007 Burgos - España Fabbricato in Spagna - Fabricado en España - Fabricat în Spania Wyprodukowano w Hiszpanii - Made in Spain...
Need help?
Do you have a question about the SKY ECO F Series and is the answer not in the manual?
Questions and answers