Support And Service - Fujitsu PRIMERGY TX120 Start Manual

8
Turning off the power and installing optional devices
Install optional devices, such as an UPS device, to be installed after the OS installation.
"Chapter 7 Installing Hardware Options"
1
Check that no medium is inserted in
the CD-ROM drive.
2
Exit the operating system (OS).
After the OS is exited, the server is automatically
turned off. When the server is not turned off after
the OS is exited, press the power switch on the front
of the server.
3
Turn off the power supply of the periph-
eral devices, such as the display.
This operation is not required when operating from
the management PC by connecting to the Remote
Management Controller port.
4
Install the optional devices.
9
Hints for error handling
In preparation for a failure, set the following:
"Chapter 5 Operations after OS Installation"
- Set to collect memory dump
If the memory dump is set, debugging information is auto-
matically saved when the STOP error occurs in the system.
This helps to analyze the cause of errors.
- Create a system restoration disk
When the system file or system environments are dam-
aged, the system can be reconstructed with the content
saved in the system restoration disk.
- Store system settings
By storing the BIOS setting information, the original in-
formation can be recovered with the stored informaion
in case of that the setting information is lost. The stored
information is also used for the system maintenance.
When the settings are completed, make sure to
check notes before operation.
"5.5 Notes before Operating the Server"
For details about maintenance after operations have
started, refer to "User's Guide Chapter 9 Operation
and Maintenance".
After optional devices are installed, set the BIOS
-
Setup Utility as required.For details about setting
procedures, refer to the "User's Guide Chapter 8
Configuring Hardware and Utilities".
- If an UPS device is installed, set the BIOS Setup
Utility as required. For details, refer to the "User's
Guide 5.5.3 Notes on Advanced Uninterruptible
Power Supply (UPS)".
When turning on the server again after turning it
off, wait for at least ten seconds and then press the
power switch.
If the server is turned on straight after being turned
off, error will occur that may be cause damage.
10

Support and Service

l PRIMERGY information
The latest PRIMERGY, driver, and software information is
available at the address below.
http://primergy.fujitsu.com
l Before requesting repairs
If an error occurs in this server, refer to "User's Guide
9.2 Troubleshooting". If problems can still not be solved,
contact an office listed in the "Contact Information".
When contacting the office listed in the "Contact Informa-
tion", inform them of the product ID and manufactures
number that are detailed on labels at the upper-right corner
of the server.
Also read the points to note about requesting repairs be-
forehand in "User's Guide 9.8.1 Contacting Maintenance
Support".
Print the "Configuration Sheets"- "Accident sheet" that
is available from Fujitsu PRIMERGY website (http://
primergy.fujitsu.com) and enter the confirmed information.
Send this sheet and the stored BIOS setting information to
your maintenance engineer.
6
����������
������� ��
������������� �
��������������������