Care & Cleaning - Sage the Fast Slow Pro BPR700 Instruction Book

Care & Cleaning
The cooker bowl, outer body, lid and
accessories should be thoroughly cleaned
before every use.
Before cleaning, ensure the cooker is turned off
by pressing and holding the STOP/CANCEL
button on the control panel. The cooker is
off when the button backlight is no longer
illuminated.
Remove the power plug from the power outlet
and remove the connector end of the power
cord from the cooker base. Allow the cooker
and all accessories to cool completely before
disassembling and cleaning.
CLEANING THE BOWL AND
OUTER BODY
1. The removable cooking bowl can be washed
in the dishwasher. However, to maintain
the ceramic coating, it is recommended
to wash the cooking bowl in warm soapy
water using a mild household detergent.
Rinse with clean water and dry thoroughly.
2. Wipe the moat and outer body with
a soft, damp sponge. A non-abrasive liquid
cleanser or mild spray solution may be
used to avoid build-up of stains. Apply
the cleanser to the sponge, not the cooker
surface, before cleaning.
3. Remove condensation drip cup by gently
pulling the bottom away from the body.
Wash in warm soapy water, rinse with
clean water, dry thoroughly and click back
into position.
4. Wipe the LCD screen with a soft damp
cloth. Cleaning with dry cloth or abrasive
cleaners may scratch the surface.
5. Let all surfaces dry thoroughly prior
to inserting the power plug into a power
outlet and turning the cooker on.
26
WARNING
Do not immerse the body, power cord or power
plug in water or any other liquid as this may
cause electrocution.
CLEANING THE LID
1. Remove the pressure release valve from
the lid.
2. Open the lid by turning the lid knob
counter clockwise and lifting lid up and off
the appliance until it is in the hinged open
position. Unscrew and remove the sealing
nut from the centre of the lid and pull
the lid away to remove from the lid arm.
3. Gently pull the silicone lid seal out from
around the wire ring on the underside
of the lid.
4. Wash the sealing nut and pressure release
valve in warm soapy water. Rinse with
clean water and dry thoroughly.
5. Wash the silicone lid seal and the lid on
the top rack of the dishwasher. Alternatively,
wash in warm soapy water, rinse with clean
water and dry thoroughly.
6. After cleaning the lid, regularly inspect
and ensure;
a) Safety locking pin moves up and down
freely. Always remove any oil or food
residue left on this area.
b) Pressure release valve and cover are clean
and free of food or liquid. To clean, twist and
pull the pressure release valve cover off the
lid, wipe with a soapy cloth, rinse and dry
thoroughly. Clip cover back into its
original position.