Safety Instructions; Maintenance - Nakayama NS1602 Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
EN

SAFETY INSTRUCTIONS

Attention: Read the manual before using the sprayer and store it for future reference.
• Do not spray flammable liquids or high temperature liquids.
• Always wear protective clothing, gloves and a mask when spraying.
• Do not spray against the wind and in high wind speed conditions.
• If spraying in light wind conditions, always spray with the wind blowing the spray away from you.
• Always release pressure before refilling, servicing or storing.
• Do not leave the sprayer unattended while pressurised.
• Chemical sprays are dangerous if swallowed or come into contact with skin. Contact the poison information center or a doctor immediately.
• Do not spray pesticide at other people and animals.
• Always refer to the mixing and safety instructions specified by the chemical supplier.
• Do not operate the sprayer for long periods of time in environments where the temperature is high.
• If the sprayer shows signs of damage or corrosion, do not operate it.
• After operation, clean the sprayer thoroughly in order to prevent pesticide from corroding the machine or blocking the spray head. This also prevents residual
pesticide from mixing with other pesticide which may cause a chemical reaction and influence the effect of the pesticide and potentially harm crops.
• Wash the sprayer thoroughly after use.
OPERATING INSTRUCTIONS
• Before operating the sprayer, wrench the cap off the container.
• Pour the medicinal liquid through the filter into the container slowly, then close the cap tightly and put the machine on your back.
• After the pressure in the air chamber is at proper levels, press the switch to start spraying.
• Adjust the nut according to the requirement of the crops in order to improve the quality of spraying.
• Depending on the task at hand, choose the appropriate spray head. Three kinds of spray heads are included with the sprayer:
Fan style spray head: Suitable for spraying low and short stalked
crops and for spraying weed killer.
Conical spray head: Suitable for spraying pesticide and insecticide.
4 hole adjustable spray head: Suitable for spraying high stalk crops
and fruit trees.

MAINTENANCE

• If the sprayer has not been used for a long time or is operated for long hours over several days, add vaseline to the sealing washer and other moving parts
to reduce wear and to reduce the rate of residue build up.
STORAGE
• After use, store the sprayer in a dry area that is out of the reach of children. Do not store the sprayer outdoors.
3
Head type
Pressure MPa
Single conical
Single fan
4 hole adjustable
Double conical
Double fan
WWW.NIKOLAOUTOOLS.GR
Flow rate L/min
0.3-0.4
0.7-0.85
0.2-0.3
0.5-0.6
0.2-0.4
0.6-1.0
0.2-0.4
1.3-1.6
0.2-0.3
0.9-1.15

Advertisement

Table of Contents
loading

This manual is also suitable for:

053576

Table of Contents