Husqvarna 236R Operator's Manual page 11

Hide thumbs Also See for 236R:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
2. Install the throttle cable (A) through the carburetor
bracket (B).
A
C
3. Turn the cable adjuster sleeve (C) into the carburetor
bracket fully.
4. Put the slot fitting (D) on the carburetor. At this time,
the recessed hole (E) for the cable lug (F) is away
from the cable adjuster sleeve (C).
G
5. Rotate the carburetor throttle cam and move the
throttle cable (A) through the slot in the slot fitting.
6. Make sure the cable lug (F) drops into the recessed
hole.
7. Operate the throttle trigger some times to make sure
that it operates correctly.
8. Adjust the cable adjuster sleeve (C).
a) Make sure the stop on the carburetor throttle
cam touches the throttle stop correctly.
b) Make sure the cable position keeps 1-2 mm
between cable lug (F) and slot fitting when the
throttle trigger is fully released.
1-2mm
9. When the throttle cable (A) is adjusted correctly,
tighten the locknut (G).
1395 - 004 - 14.09.2020
10. Connect the stop switch wires (H) with the
B
11. Install the stop switch wires and connectors with
D E
F
12. Install the dust cover (J).
13. Install the air filter cover.
To install blades and trimmer heads
1. Make sure that the lifted section on the drive disc/
connectors from the engine.
H
clamp (I).
J
WARNING: Only use the approved guard for
Accessories on page 27 . A
the blades. See
defective guard can cause injury.
WARNING: If you operate the product with a
grass blade, first install the correct
handlebar, blade guard and harness .
WARNING: If you do not install the the
blades correctly, it can cause injury.
support flange engages correctly in the center hole
of the blades.
I
11

Advertisement

Table of Contents
loading

Table of Contents