Advertisement
troubleshooting
problem
Tool will not start.
Blast flow surges /
Excessive abrasive consumption.
Clogging and plugging of blast flow. Excessive debris in abrasive.
Lack of abrasive flow.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect air supply before service.
Page 12
possible causes
1. Compressor not on.
2. Air line not connected properly.
Air pressure too low.
1. Hopper empty.
2. Moisture in abrasive
3. Not enough air pressure.
4. Air hose kinked.
5. Excessive debris in abrasive.
For technical questions, please call 1-888-866-5797.
Likely Solutions
1. Turn compressor on.
2. Check that air line is connected.
Increase air pressure.
Purge and filter abrasive.
1. Fill hopper.
2. Use dry abrasive.
3. Increase air pressure.
4. Un‑kink air hose.
5. Clean or filter abrasive.
Item 59490
Advertisement
