Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co., Ltd.
(2) Open the serial port debugging assistant and the network debugging assistant, set the parameters of the serial port
assistant to the parameters set by DTU just now, open the serial port, set the protocol type of the network debugging assistant
to TCP UDP, and set the local IP address of the network debugging assistant to DTU. The destination IP address, and the local
port of the network debugging assistant is set to the destination port of DTU, the local port of the network debugging assistant
is set to the destination port of the DTU, and click Connect.
(3) Enter a string of data in the sending area of the serial debugging assistant and click Send. Users can see that the
network assistant received the same data in the sending area of the serial port debugging assistant. Enter a string of data in
the sending area of the network debugging assistant, the serial assistant also receives the same data in the network
transmission area and realizes two-way transparent transmission.
Copyright ©2012–2017，Chengdu Ebyte Electronic Technology Co., Ltd.
Figure 6-11 Parameter setting
图 6-13 数据透传
E810-DTU(4RS1E) User Manuel
20
Advertisement
Table of Contents
