Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co., Ltd.
(2) Open the serial debugging assistant and the network debugging assistant, set the parameters of the serial assistant to the
parameters set by DTU just now, open the serial port, set the protocol type of the network debugging assistant to TCP Client, and
set the server IP address of the network debugging assistant to DTU IP address, the server port of the network debugging assistant
is set to the local port of DTU, and click Connect.
(3) Enter a string of data in the sending area of the serial port debugging assistant and click Send. Users can see that the
network assistant received the same data in the sending area of the serial port debugging assistant. Enter a string of data in the
sending area of the network debugging assistant, the serial port assistant also receives the same data in the network transmission
area and realizes two-way transparent transmission.
Copyright ©2012–2017，Chengdu Ebyte Electronic Technology Co., Ltd.
Figure 6-3 Parameter setting
E810-DTU(4RS1E) User Manuel
16
Advertisement
Table of Contents
