Table of Contents
Advertisement
No.
Name
1) Indicator LEDs
10BASE-T/100BASE-TX
2)
interface connector
(RJ45)
RS-232 interface
3)
connector
RUN/STOP/MODE
4)
*1
switch
5) RESET/SELECT switch
6) Battery
7) Battery connector pin
*1
Operate the RUN/STOP/MODE switch and RESET/SELECT switch by hand.
Using a screwdriver or any other tool can cause a failure.
4.2 LED indicator specifications
Refer to Section 4.2 for the indicator LEDs.
Connector used to connect the C Controller module to
10BASE-T/100BASE-TX.
(The C Controller module determines 10BASE-T or
100BASE-TX depending on the target device.)
Connector used to connect the C Controller module to RS-
232.
Refer to Section 4.3.1 for the RUN/STOP/MODE switch.
*1
Refer to Section 4.3.2 for the RESET/SELECT switch.
Used for protecting the standard ROM files, and backing up
the battery-backed-up RAM data and the clock data.
For connection of the battery lead wire.
(The lead wire is shipped disconnected from the connector to
prevent battery consumption.)
-B
RUN
MODE
STS
ERR.
CH2 SD/RD
USER
Description
CH1 10BASE-T/
100BASE-TX
20
100
M
SD/
RD
Advertisement
Table of Contents
