Table of Contents
Advertisement
4.2
4.2.1
w
n
4.2.2
4.2.3
22
3.
Open the Operating Setpoint control screen.
Setpoint
60°C
MIN
40°C
ACCEPT
4.
Change the water temperature setpoint:
a)
Use [+] to increase the setpoint.
b)
Use [-] to decrease the setpoint.
5.
Press [ACCEPT] to confirm the value or press [BACK] to return to the previous
screen.
Turn off the water heater
Turn off for a short period
To turn off the water heater for less than 2 months, set the control switch on the front of
the water heater (see 1) to 0.
Warning
The power of the water heater stays on when the control switch is set to 0.
Note
If the water heater is in OFF mode for more than 2 months and no water is drained, air
bubbles may be formed in the water heater. This can lead to air in the water pipes.
Isolate from the mains
To isolate the water heater from the mains:
1.
Set the control switch to 0.
2.
Disconnect the water heater from the mains by turning the isolator.
Turn off for a long period
When the water heater needs to be turned off for more than 2 months, contact your
service and maintenance engineer to decommission the water heater.
MAX
85°C
BACK
User part
Advertisement
Table of Contents
