Appliance Equipment; Installation - BOMANN 707230 Instruction Manual

• In case of damage, do not put the appliance into
operation. Contact your distributor.
NOTE:
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
"Cleaning and Maintenance"
according to chapter

Appliance Equipment

Appliance overview
1 Chilling compartment
with drip tray
2 Temperature control /
Interior light
Delivery scope
2x Glass shelf, 1x vegetable box, 3x door storage
rack, 1x egg tray, 1x ice cube tray, 1x condensation
drip tray (below chilling compartment)

Installation

Conditions for the installation location
• Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
.
3 Door storage racks
4 Glass shelves
5 Vegetable box
6 Feet
Gap to the back approx. 50～70 mm, to the
-
side walls and above the device each approx.
min. 100 mm;
Place the appliance so that the appliance door
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
The climate class can be found under
Data"
and on the rating label located in the interior
or on the appliance rear.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
- near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Leveling the appliance
Slight unevenness in the floor can be leveled out
using the front feet.
Check whether the appliance is leveled horizontally.
If the appliance is not in balance, the feet must be
adjusted.
Electrical connection
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
19
"Technical