English - Bosch EasyAquatak 120 Original Instructions Manual

12 | English

English
Safety Notes
Explanation of symbols
General hazard safety alert.
Never direct the water jet at
people, animals, the machine
or electric components.
Warning: High pressure jets can be
dangerous if subject to misuse.
According to the applicable
regulations, the appliance
must never be used on the
drinking water network without a
system separator. Use a separator
as per IEC 61770 Type BA.
Water flowing though a system sep-
arator is considered not drinkable.
Safety Notes for pressure washer
Read all safety warnings
and all instructions. Failure
to follow the safety warnings
and instructions may result in electric
shock, fire and/or serious injury.
The warning and information signs
attached to the unit provide import-
ant information for safe operation.
Apart from the information in the
operating instructions comply with
the general safety regulations and
regulations for the prevention of ac-
cidents.
F 016 L94 123 | (27.07.2020)
Connecting to the mains
The voltage of the power source
u
must correspond with the data on
the type plate of the product.
We recommend that this product is
u
only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA resid-
ual current.
The circuit breaker supplying mains
u
power to the high-pressure washer
should have no less than a C16 rat-
ing. If in doubt consult a qualified
electrician for further advice. Do not
attempt to modify your electrical
system yourself.
Remove the plug from socket
u
whenever the machine is left unat-
tended for any period.
The electric supply installation
u
should comply with IEC 60364-1.
If the supply cord is damaged, it
u
must be replaced by the manufac-
turer, its service agent or similarly
qualified persons in order to avoid a
hazard.
If the plug is damaged, pay attention
u
to the following:
Plugs and sockets situated near the
u
work site or outdoors should be to
class IP 55 of BS 5490 to provide
adequate protection against ingress
of water, etc. and cable entries re-
quire effective sealing. Rubber
shrouds should be provided over
cable glands. Drip-proof (class IP X2
of BS 5490) plugs and sockets to BS
Bosch Power Tools