Meccanica Benassi FOX 95-2WD User And Maintenance Manual page 30

Page 30 of 36
■) Rotor CASING clogged
-) The terrain is too wet => Clean the casing internal part more frequently, raise the cutting height,
consider if more than one attempt is needed, or work when the weather is drier.
-) Worn blades => Replace them, as a poor grinding due to a worn-out cutting element leads to
further build-ups.
■) THE MACHINE DOES NOT BRAKE even if the tyres have a good grip
-) The pedal brake does not work as it should => Immediately contact an authorised workshop.
■) THE ENGINE DOES NOT TURN OFF moving the key to OFF
-) Faulty electrical system => Disengage the rotor, wait it to stop, bring the throttle to the
minimum, get up from the seat and wait until the machine turns off before getting off. Before any
further use, have it checked by a service centre.
■) TYRES are subject to frequent punctures
-) If this is due to the type of terrain and vegetation to be cut (and not to faults on rims or valves)
=> consider the use of an anti-puncture gel.
■) The BATTERY does not charge
-) The wiring charging circuit does not work properly => check the 20 A fuse, replace it and try
again
-) The engine alternator does not work properly =>
-) Faulty battery => replace it.
■) THE TRAVEL DIRECTION PEDAL does not return in neutral position when the foot is raised
-) The cable connected to the pedal does not move properly and struggles coming back =>
Lubricate it.
-) The pedal support pin does not move properly => Lubricate it.
Briggs & Stratton
service centre.
35451490EN - FOX 95-2WD User and Maintenance Manual