Engine Oil - Meccanica Benassi FOX 95-2WD User And Maintenance Manual

Page 22 of 36
If the level is low, fill up according to the need, with the same type of oil used for the first fill.
For complete oil replacement operations and subsequent discharge, it is advisable to contact a specialised
service centre.

ENGINE OIL

Further information is available in the engine manufacturer manual (
with this machine manual. It is essential to read and understand such document in its entirety as well. In
fact, the engine warranty is covered by the engine manufacturer through its service centres located on the
territory. Below is a summary of the main information.
Briggs and Stratton
ENGINE OIL TYPE: The correct engine oil viscosity is
determined by the external temperature. Use the
references below to choose the most suitable type of oil
according to the work temperature.
A ► SAE 30
: Below 4°C (40°F), using SAE 30 will cause
a difficult start-up.
B ► 10W-30
: Above 27°C (80°F), using 10W-30 can
cause higher oil consumption. Check the oil level more
frequently.
C ► 5W-30
synthetic:
D ► 5W-30
: winter use only
Before topping up or checking the engine oil level:
- Make sure that the machine is on a flat surface.
- Remove all debris from the oil filling area. Carry out
the following operations only with the engine off and
cold, with its ignition key removed.
Check and possible top-up:
1) Remove the level dipstick A (see figure on the side)
and clean it with a cloth.
2) Install and tighten the dipstick again.
3) Extract the dipstick and check the oil level. The
correct level corresponds to the upper mark indicated
on the dipstick (B, see figure 6).
4) If the oil level is low, fill up slowly through the
filling hole C in figure 6. Do not add too much oil.
After having added the oil, wait for one minute before
checking the level once again.
5) Reinstall and tighten the level dipstick A.
35451490EN - FOX 95-2WD User and Maintenance Manual
), supplied together
covers all fields of application