Table of Contents
Advertisement
Page 27 of 36
- on the casing right side, there is an external hose that reaches the bearing, which otherwise would be
inaccessible;
- on the casing left side, the grease nipple is located directly on the bearing.
BEVEL GEARBOX: oil level check and possible replacement
The gearbox in the figure on the side is located on the machine right
side (from the operator's point of view). It comes pre-loaded in the
factory with the right amount of oil. However, as previously said, it is
advisable to carry out:
- EVERY 50 HOURS: Level check. During belt check operations, which
are scheduled at the same intervals, also inspect the gearbox, checking
that the level is at the centre of the indicator (see Fig. on the side).
- EVERY 500 HOURS: Total replacement. Drain the old oil from the
discharge hole and insert the new one (type: CLP 220 or 80W-90) from
the filling hole (after disassembling the vent pipette, not shown in the
figure).
This general guide cannot entirely replace the expertise of an Authorised Workshop, which perfectly knows
the product. If the following suggestions are not useful enough to fix a specific issue, it is recommended to
contact a service centre.
In case of shock, drift, tip-over or generic damage, even if the machine seems to be intact, it must be
inspected as soon as possible by an authorised workshop. It is necessary to check whether the functional
and structural parts (frame, engine, hydrostatic axles) are damaged and that there are no liquid spills.
NOTE: even if at first sight no damage is found, the in-depth inspection must be carried out anyway: some
faults can be overlooked by an unexperienced user!
■) The STARTER does not turn
-) Start-up electrical consent absent => see CHAP. 6b.
-) Fuses to be replaced => see CHAP. 6b.
7e – TROUBLESHOOTING
35451490EN - FOX 95-2WD User and Maintenance Manual
Advertisement
Table of Contents
