Sony SRG-A40 Operating Instructions Manual page 63

Installation
System
Configure the camera installation setting.
Menu item Detail and setting
value
Image Flip On/Off
IR Remote On/Off
Tally Lamp High/Low/Off
Brightness
Tele Convert On/Off
Menu Overlay On/Off
(SDI)
Menu Overlay On/Off
(HDMI)
Standby Mode Neutral/Side
Initial setting value Content
of the factory
default setting
Off Performs the image flip vertically.
Set to On when the camera is installed on the ceiling.
Note
When the [Image Flip] setting is changed, the
coordinates for pan and tilt are flipped, and the
following are reset.
– Pan-Tilt limit (PAN-TILT LIMIT)
– Preset
– PTZ Auto Framing setting
On Sets whether the operation by the supplied remote
commander is valid or invalid.
When using the supplied remote commander, turn it
on to use.
Low Sets the brightness of the tally lamp.
Select Off to not light up the tally lamp.
Off Sets tele convert.
Turn to on to shoot using 2× magnification.
Notes
• This is enabled only when the SYSTEM SELECT
switch or format setting of video output is set to
1920×1080.
• Setting [Tele Convert] to [On] narrows the angle of
view.
• When the [Tele Convert] setting is changed, set
[Start Position] and [Detection Settings] of [PTZ
Auto Framing Settings] again.
On Sets the OSD menu output to the SDI image.
Turn to off in order not to output the OSD menu or
message to SDI OUT.
On Sets the OSD menu output to the HDMI output image.
Turn to off in order not to output the OSD menu or
message to HDMI.
Neutral This is a function to move the pan position to the end
automatically when the camera enters standby mode.
[Neutral]: The pan position is not moved
automatically.
[Side]: The pan position is moved to the end
automatically.
Notes
• When the mode is set to [Side], the pan position is
moved to the end, exceeding the limit even if the
Pan-Tilt limit is specified.
• After the camera is turned on from standby mode,
the camera position moves to the position
recorded on PRESET1.
63