Haier ES50V-F1(EU) Instruction Manual page 9

For TF7/VH3 Series, the vertical installation method is as follows:
Refer to Figure 1 of the Installation Schematic, and drill two holes in the wall using an
1.
percussion drill to match the accessory expansion hook according to the dimensions shown
in Figure 3.
Insert the expansion hook into the wall hole and fix it, then hang the water heater onto the
2.
hook.
Install the safety valve and other accessories with reference to the "Installation of Safety
3.
Valve" (for installation reference only). Be careful to add thread seal tape seal to prevent
water leakage.
For TF7 Serie, the horizontal installation method is as follows:
Refer to Figure 4 of the Installation Schematic, and drill two holes in the wall with an
1.
percussion drill to match the accessory expansion hook according to the dimensions shown
in Figure 5.
Insert the expansion hook into the wall hole and fix it, then hang the water heater onto the
2.
hook.
Install the safety valve and other accessories with reference to the "Installation of Safety
3.
Valve" (for installation reference only). Be careful to add thread seal tape seal to prevent
water leakage.
9