Table of Contents
Advertisement
OPERATION
HANDHELD CONTROLLER
All controls utilized during normal operation of the EH-200 are located on the
handheld controller.
2
4
6
7
1. Microphone – The microphone for talk.
2. ON/OFF –Power on/off and standby. It provokes the power of the siren
system. By depressing this button, the backlights are lit in blue, and the power
of the siren is turned on, press and hold it for two seconds, the power is turned
off. This button can also bring the siren into standby mode. While depressing
this button all of function will be stopped instantly to standby.
3. PTT (Push To Talk) – Press and hold this button will mute all siren sound
and instantly enable PA function. Releasing this button will revert the tone
back to what EH-200 was sounding. You may Change the PTT volume by
1
1．Microphone
3
2．Power On/Off
3．Push To Talk
5
4．Manual
5．Air Horn
6．Tone selecting
8
7-8．Lighting Control
adjusting the "PTT gain" trimmer on back of siren amplifier.
4. Manual – The momentary button. With no siren sound, depressing this
button once provoked "Peak and Hold" sound. "Coast Down" sound is
spawned as this switch is released.
5. AIR – The momentary button. With no siren sound, depressing this
button once creates "Air Horn" sound. The sound ceases as soon as the button
is released.
6. Tone selecting – siren tone selecting button, depressing this button's right
once, it will scroll through different sirens tones, they are: Yelp, Hi-Lo,
Hyper-Lo, Hyper-Yelp, Whoop, Wail, standby, depressing this button's left
once, it will scroll through reverse different sirens tones, they are: Wail, Yelp,
Hi-Lo, Hyper-Lo, Hyper-Yelp, Whoop, standby.
7-8. Lighting Control –
the buttons for the light control, depress the
relevant button, the relevant indicator light will be lighted, it indicates the
light is working on.
On the standby mode, the siren will be powered off after 70 minutes.
Advertisement
Table of Contents
