Related Manuals for Abrams EH-200
Summary of Contents for Abrams EH-200
- Page 1 Expedition Series Remote Siren System MODEL EH-200 INSTALLATION AND OPERATION INSTRUCTION...
-
Page 2: Instruction Of Operation
EH-200 provides a highly versatile electronic siren system. OUTPUT 1……………10A maximum The EH-200 must be installed under the seat, in the truck or on the dash of OUTPUT 2……………10A maximum any vehicles with 12 volts, negative ground chassis system. Connection... - Page 3 Improper use of the speaker or of its installation will reduce the efficiency of sound output, which results in degrading the alert effectiveness. Be also aware that the use of EH-200 does not give you the right to force your way through...
- Page 4 "Peak and Hold" sound. "Coast Down" sound is spawned as this switch is released. All controls utilized during normal operation of the EH-200 are located on the handheld controller. 5. AIR – The momentary button. With no siren sound, depressing this button once creates "Air Horn"...
-
Page 5: Installation
File a claim immediately with the function of the "AIR" button on the handheld controller. To use HORN-TAP carrier stating the extent of the damage if the EH-200 has been damaged. feature, the HORN RING IN and HORN RING OUT on the amplifier box Carefully check all enveloped, shipping labels and tags before removing should connect to the vehicle’s horn ring switch. - Page 6 Do not connect the EH-200 system to vehicle battery until all The unit is supplied in the accessory kit with a eight-position, other electrical connections are made and mounting of all pluggable connector to accommodate the other electrical components is complete.
- Page 7 Then connect the wire to "POS+" position of the connectors on when the amplifier is energized. EH-200. Connect the other ends of the wires directly to the positive terminal of the vehicle battery. 4. Lightbar Control – To install the lights control wires, strip approximately 1/4″of insulation from the end of the lights wires.
-
Page 8: Testing After Installation
To properly service an electronic siren, you must have a good understanding of automotive electrical systems and emergency signaling procedures. Most of the components and electronic parts used in the model EH-200 are standard items that can be obtained from any electronics supply shop. To reduce equipment down-time, the factory recommends that the entire amplifier’s printed circuit board (part No. - Page 9 Make certain that the speaker(s) is (are) not defective before reinstalling the repaired EH-200. After servicing is complete, perform a test of all functions to ensure siren is operating properly. Whenever the siren is tested, be aware of...