Table of Contents
Advertisement
Wire Your Switch
Step 1. Turn Off Power and Remove the Wallplate
Turn off
the circuit breaker. Then remove the old wallplate of the wall
switch and label the wires.
CAUTION
Risk of Electric Shocks - High Voltage - Disconnect power supply before servicing.
MISE EN GARDE
Risque d'électrocution - Haute tension. Débrancher l'alimentation électrique avant d'utiliser.
Step 2. Expose Your Switch Wiring
Remove the screws securing your old switch to the wall box. Gently
pull the switch out and disconnect wires from the old switch.
Step 3. Label and Connect the Wires
Label the wires. Use the wire nuts to connect your smart switch to the
wall box as shown below.
Note: No need to distinguish between Line and Load wires.
5
Advertisement
Table of Contents
