Zennio LUMENTO X3 Technical Documentation

RGB CONTROLLER
ZN1DI‐RGBX3
MAIN FEATURES
Control of RGB LEDs or 3 independent channels.
External power supply required (12-24 VDC).
LEDs test function
KNX BCU integrated
KNX and CE mark
SIZE AND DESCRIPTION
N Element
1 KNX Connector
2 KNX Programming button
3 KNX Programming and internal test LED
4 Test button
5 Test LED and Reversed polarity indicator
6 External power supply terminal block
7 LEDs control terminal block
KNX Programming button: a push button to set the programming mode. If this button is held while plugging the device into the
KNX bus, it goes into secure mode.
KNX Programming and internal test LED: the red LED indicates programming mode. When the device goes into secure mode, it
blinks red every 0.5 seconds. The blinking blue LED indicates internal test.
Test button: it tests the functioning of channels connected to the device. Push and hold for 3 seconds to get in/out of the testing
mode.
Test LED and polarity: tricolored LED that indicates which channel (red=channel 1/R, green=channel 2/G, blue=channel 3/B) is
being tested. White light indicates that the device is in test mode. Orange light indicates reverse polarity in external power supply.
GENERAL SYSTEM SPECIFICATIONS
Type of device
Voltage
Voltage range
KNX Supply
Power consumption
Bus connection
External Power Supply
Power Supply cable section
Type of control
Ambient Temperature
Storage Temperature
Ambient Humidity
Storage Humidity (relative)
Complementary Characteristics
Safety Class
Operation Type
Device Action Type
Electrical solicitations period
Type of Protection
Assembly
Power Failure response (bus)
Response when restarting (bus)
© Zennio Avance y Tecnología S.L.
Electric Operation Control Device
29V DC SELV
20...31V DC
145 mW
Typical BUS connector TP1, 0.50mm2 section
12 – 24V DC
1.5 mm² to 2.5 mm²
PWM (150, 300, 488 ó 600 Hz)
0ºC to +45ºC
-5ºC a +50ºC
30 to 85% RH (no condensation)
30 to 85% RH (no condensation)
Class B
II
Continuous operation
Type 1
Long
IP20
Independent control assembly device
Connect Lumento as near as possible to both, the LED to dimmer and the external power supply
Data saving
Data saving
Edition 4
2
1
6
Further information www.zennio.com
LUMENTO X3
LED DIMMING
Technical Documentation
7
4
3
Page 1 / 2
5