Advertisement
Greasing Frequency should be as many times as necessary to maintain a small film of grease leaking at the seals.
This will protect against foreign materials entering the bearing. The following list is provided to aid you in
acquiring the proper grease or an equivalent.
2.
REPLACEMENT - If replacement of bearings become necessary remember to clean off the shaft, file
smooth grooves or set screw marks, and oil the shaft before slipping on the new bearing.
IF BEARING DOES NOT SLIDE ON EASILY, USE A SOFT
CAUTION
!
METAL BAR TO TAP AGAINST THE INNER RACE TO ASSEMBLE.
3.
GENERAL - Set up a weekly check on all bearings to ensure they remain tightly bolted down, set
screws remain fastened securely and are properly lubricated.
V-BELT & SHEAVES
If provided on your drive package, V-Belt tension & sheave alignment are important for extended belt life. Read the
following list over for proper maintenance or installation.
1.
Never pound sheaves on or off a shaft. Make sure that the shaft diameter and sheave bore is properly
sized. If there are burrs caused by set screws or sharp edges on the keyway or keyseat, remove
carefully with emery cloth and/or file. Clean off metal particles and dirt from the shaft and sheave
before installation.
2.
Sheaves must be in line with each other and installed on shafts which are parallel with each other.
3.
DO NOT FORCE or use the drive to install a V-belt. Have driven components loose to install the belt(s).
NORMAL DUTY
Texaco - Multifak #2
Mobile - Mobilux #2
Amoco - Lithium MP
Shell - Alvania #2
FIGURE 11
HEAVY DUTY
Sun - Prestige 742EP
Exxon - Lidok #2EP
Arco - Litholene HEP2
Shell - Alvania #2EP
13
5/12
Advertisement
