Approvals And Certifications; Eu Declaration Of Conformity; Fcc Compliance Notice - Danfoss OPX Series User Manual

5.

Approvals and certifications

5.1

EU Declaration of Conformity

The Control Panels comply with the following directives:
2014/53/EU
2011/65/EU
The following standards were consulted to assess conformity:
EN 300 328 v2.2.2
EN 300 330 v2.1.1
EN 301 489-1: v2.2.3 -17: v3.2.4
EN 60529:1991+A1:2000+A2:2013
IEC 62368-1: 2018
The CE symbol confirms that this product conforms with the above-mentioned norms and
regulations.
The complete DoC can be found on Danfoss website: www.Danfoss.com.
5.2

FCC compliance notice

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by 1 or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/television technician for help.
Radio Equipment Directive
RoHS Directive: Restriction of the use of certain hazardous substances
Classified as Business