Hitachi WF 4DY Handling Instructions Manual page 7

Slider
B section
A section
Belt guide
Collated screw
strips
(View from under)
Fig. 12
Set one screw
forw ard.
(View from front)
Screw m ark
30°
1 screw forw ard
NOTE:
If the tape is not set as show n in the figure, the
bit can dam age the board surface (inadequate feed)
and screw s can be w asted (excess feed).
2. Removal
When the screw s on the tape run out or to rem ove
a half used belt of screw s, pull the tape out in the
\ direction as show n in Fig. 16.
Collated screw
strips
Top adjuster
Fig. 16
Fig. 13
Slider
Screw
in position
Fig. 14
Fig. 15
HOW TO USE THE AUTOM ATIC
SCREWDRIVER
1. Operations
When you pull the sw itch and press the driver
straight against the w orkpiece in continuous
operation m ode, the screw is fed and screw ed in
autom atically. (Fig. 17)
Fig. 17
NOTE
M ake sure that the rotation direction is correct before
the screw is tightened.
Refer to item 4 for further details of the roation
direction changeover procedures.
2. Number of screw tightenings possible
(w ith one charge)
Please refer to the table below for the num ber of
screw tightenings possible w ith one charge.
Screw used
Board screw r25
Board screw r41
These values m ay vary slightly, according to em bient
tem perature and battery characteristics.
3. Tightening at a corner and adjustment operation
When the screw is tightenined, retightened or
rem oved in a location w here the tightening is
im possible if the screw feed attachm ent is installed
in the m ain body, such as at right next to a w all
or colum n, rem ove the screw feed attachm ent before
operation. (Fig. 18)
Fig. 18
4. Sw itch operation, changing the direction of rotation
The bit rotates clockw ise (view ed from the rear side)
by pushing the R-side of the push button.
The L-side of the push button is pushed to turn the
bit counterclockw ise. (See Fig. 19).
and m arks are indicated on the m ain body.
English
No. of tightenings
Approx. 450
Approx. 220
6