Safety; Important Provisions For All Products - MTU 12V 4000 L64 Operating Instructions Manual

1 Safety

1.1 Important provisions for all products

General information
This product may pose a risk of injury or damage in the following cases:
• Incorrect use
• Operation, maintenance and repair by unqualified personnel
• Changes or modifications which are neither made nor authorized by the manufacturer
• Noncompliance with the safety instructions and warning notices
Nameplates
The product is identified by nameplate, model designation or serial number and must match with the infor-
mation on the title page of this manual.
Nameplates, model designation or serial number can be found on the product.
All EU-certified engines delivered by MTU come with a second nameplate. When operating the machine in the
EU: The second nameplate must be affixed in a prominent position as described in the accompanying specifi-
cations.
Emission regulations and emission labels
Responsibility for compliance with emission regulations
Modification or removal of any mechanical/electronic components or the installation of additional compo-
nents including the execution of calibration processes that might affect the emission characteristics of the
product are prohibited by emission regulations. Emission control units/systems may only be maintained, ex-
changed or repaired if the components used for this purpose are approved by the manufacturer.
Noncompliance with these regulations will invalidate the design type approval issued by the emissions regu-
lation authorities. The manufacturer does not accept any liability for violations of the emission regulations.
The product must be operated over its entire life cycle according to the conditions defined as "Intended use"
(→ Page 6).
Replacing components with emission labels
On all MTU engines fitted with emission labels, these labels must remain on the engine throughout its opera-
tional life.
Exception: Engines used exclusively in land-based, military applications other than by US government agen-
cies.
Please note the following when replacing components with emission labels:
• The relevant emission labels must be affixed to the spare part.
• Emission labels shall not be transferred from the replaced part to the spare part.
• The emission labels must be removed from the replaced part and destroyed.
MS15027/04E 2017-08 | Safety | 5