Yamaha VIKING Owner's Manual page 164

2. Remove the tail/brake light bulb holder
(together with the bulb) by turning it coun-
terclockwise.
8
1. Tail/brake light bulb holder
3. Push the burnt-out bulb in and turn it
counterclockwise to remove it from the
bulb holder.
4. Push a new bulb in and turn it clockwise
to install in the bulb holder.
5. Install the bulb holder (together with the
bulb) by turning it clockwise.
6. Install the panel.
1
7. Install the quick fastener screws, bolts
and nuts and then tighten the nuts to the
specified torque.
Tightening torque:
Panel nut:
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
8-54