Care And Storage; Post-Operation Care; Flushing The Cooling Water Passages - Yamaha WaveRunner EX 2023 Owner's/Operator's Manual

Care and storage

EJU37148

Post-operation care

EWJ00332
Always place the watercraft upright in a
horizontal position when storing it, other-
wise fuel could leak out into the engine or
engine compartment, which could create
a fire hazard.
After using the watercraft, always take it out
of the water, clean it, and store it. Leaving the
watercraft in the water for extended periods
will accelerate the rate of normal deteriora-
tion of the jet pump and hull. Marine organ-
isms and corrosion are some of the
conditions that can shorten the life of many
watercraft components.
EJU44560

Flushing the cooling water passages

ECJ01311
Do not run the engine over 4000 r/min on
land. Also, do not run the engine for more
than 15 seconds without supplying water,
otherwise the engine could overheat.
Flush the cooling water passages to prevent
them from clogging with salt, sand, or dirt.
(1) Place the watercraft in a horizontal posi-
tion.
(2) Remove the seat and seat storage com-
partment. (See page 43 for seat removal
and installation procedures and page 47
for information on the seat storage com-
partment.)
(3) Connect the garden hose adapter to a
garden hose.
78
1
1 Garden hose adapter
2 Garden hose
(4) Loosen the flushing hose connector cap
and remove it. Insert the garden hose
adapter into the flushing hose connector
by pushing and twisting it until it is se-
curely connected.
2 3
1
1 Flushing hose connector cap
2 Flushing hose connector
3 Garden hose adapter
(5) Connect the garden hose to a water tap.
(6) Make sure that the area around the wa-
tercraft is clear, and then start the en-
gine. Immediately after the engine starts,
fully turn the water supply on so that wa-
ter flows out continually from the jet
thrust nozzle.
2