Yamaha WaveRunner EX 2023 Owner's/Operator's Manual page 67

Table of Contents

Advertisement

Check the start switch, the engine stop
switch, and the engine shut-off switch for
proper operation. (See pages 31 to 31 for in-
formation on operating each switch.)
1 Start switch
2 Engine stop switch
3 Engine shut-off switch
4 Clip
5 Engine shut-off cord (lanyard)
To check the operation of the switches:
(1) Push the start switch to make sure that
the engine starts.
(2) As soon as the engine starts running,
push the engine stop switch to make
sure that the engine stops immediately.
(3) Restart the engine, and then pull the en-
gine shut-off cord (lanyard) to remove
the clip from the engine shut-off switch
to make sure that the engine stops im-
mediately.
EJU40102
Storage compartment checks
Make sure that the storage compartments
are not damaged and that water has not col-
lected in the compartments. (See page 45 for
information on the storage compartments.)
EJU44670
Fire extinguisher holder checks
Make sure that the fire extinguisher holder is
installed in the correct direction and is not
damaged. (See page 47 for information on
the fire extinguisher holder.)
1
3
4
2
5
Pre-operation checks
EJU44621
Fire extinguisher check
Check that there is a full fire extinguisher on
board.
To check the fire extinguisher, see the in-
structions supplied by the fire extinguisher
manufacturer. Always keep the fire extin-
guisher stored in the holder.
Always carry a fire extinguisher on board. A
fire extinguisher is not standard equipment
with this watercraft. If you do not have one,
contact a Yamaha dealer or a fire extinguish-
er dealer to obtain one meeting the proper
specifications.
Fire extinguisher:
Classification:
5-B (B-1)
Capacity:
2 lb or more
EJU40122
Safety equipment check
Check that safety equipment meeting the ap-
plicable regulations is on board.
EJU32353
Hull and deck check
Check the hull and deck for damage or other
problem.
EJU32657
Jet intake checks
Make sure that the jet intake is not damaged
or clogged with weeds or debris. If the jet in-
take is clogged, clean it. (See page 93 for in-
formation on the jet intake.)
61

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents