Advancing The Line Manually; Operating Tips - Toro Flex-Force Power System 51832 Operator's Manual

Advancing the Line
Manually
Remove the battery pack from the trimmer, then push
the bump button at the base of the spool retainer
while pulling on the trimmer line to manually advance
the line.
Adjusting the Cutting Swath
The trimmer comes from the factory with a cutting swath of 33 cm (13 inches) as shown in A of
to the following instructions to adjust the swath to 38.1 cm (15 inches) as shown in D of
1. Remove the swath blade from the bottom of the guard by removing the 2 screws holding it in place using
the provided Allen wrench (B of
2. Once the swath blade is rotated, install it onto the guard using the 2 screws previously removed (C of
Figure 13).

Operating Tips

•
Keep the trimmer tilted toward the area being cut;
this is the best cutting area.
•
The string trimmer cuts when you move it from
right to left. This prevents the trimmer from
throwing debris at you.
•
Use the tip of the string to do the cutting; do not
force the string head into uncut grass.
•
Wire and picket fences can cause the string to
wear rapidly and even break. Stone and brick
walls, curbs, and wood can also cause the string
to wear rapidly.
•
Avoid trees and shrubs. The string can easily
damage tree bark, wood moldings, siding, and
fence posts.
Figure 13) and rotate the swath blade 180°.
Figure 13
1. Direction of rotation
14
Figure 13. Refer
Figure 13.
Figure 14
2. String path
g339778
g330996