TurboAnt X7 Max User Manual page 16

The battery power is full
or the battery has failed.
The current speed is
below the minimum
speed required for cruise
Cruise
control.
control
cannot be
A constant speed is not
activated.
maintained.
The screws on the stem
The stem
folding spanner are
is loose.
loose.
The scooter is set at
"non-zero" start and has
not been manually
The scooter
started.
cannot
accelerate.
The throttle is not
released.
Normal tire pressure is between 31.9-34.8 psi (220-240 kPa). It is necessary to periodically
check the scooter to make sure all parts are in good condition, including the throttle,
remaining power, tire pressure, and more.
The tubed pneumatic tires
may have an air leak if
they have been stored for
The tire has
a long period. This is
an air leak.
normal, as most air tires
require pumping
periodically.
After confirming that the charging adapter is
functioning, connect the charging adapter to the
AC power source and the charging port on the
stem.
1. If the indicator light turns red, then charging
is normal and the battery is in good working
condition.
2. If the indicator light turns green, then the
battery is full or has reached its end of life. In case
of failure, replace the battery.
Cruise control can only be activated when
travelling at speeds greater than 3.7 mph
(6 km/h). Increase speed to enable cruise
control.
Keep a constant speed. Then, hold the throttle in
the same position for 6 seconds to enable cruise
control.
Tighten the screws on the stem folding spanner.
Use your foot to give the scooter an initial
momentum. When the scooter's speed reaches
1.9 mph (3 km/h), the scooter can be accelerated.
The throttle is equipped with an electric lock, so it
needs to be completely pressed down in order to
accelerate the scooter.
Pump up the tires by taking the scooter to an
automobile or motorbike repair center, or any
location with a proper air compressor. Standard
bicycle pumps can also be used to pump up the
scooter tires.
14