Table of Contents
Advertisement
equipment rack. Adequate ventilation is required when installed to
prevent possible damage to the AURORA1600-4K components.
Connect required cables for signal input and output.
3.
Connect power source using the included power cord.
4.
Connect the power cord to the rear panel.
5.
Fasten the power protect accessory.
6.
As a final step, power AURORA1600-4K on.
7.
Restore the default IP setting
AURORA1600-4K provides an Ethernet port for connecting with a
computer to access the network control page or run the device control tool
to modify the network settings. The default IP address of
AURORA1600-4K is 192.168.1. 2.
Restore the default IP setting by USB interface at the rear panel.
The instructions are as below:
◼ Operations:
Firstly, power down the AURORA1600-4K device, insert the U disk which
has the IP restored program.
Secondly, power on AURORA1600-4K and keep it running for at least 60
seconds, thus, the IP address of AURORA1600-4K will be restored to the
default one.
At last, power off the AURORA1600-4K again, and pull out the U disk from
the USB interface, then power on the AURORA1600-4K, it will run
normally.
Unpack and Installation
9
Advertisement
Table of Contents
