Table of Contents
Advertisement
Handle
Alignment
Holes
Frame
Assy.
STEP 1: Attach the handle to the
frame of the pressure washer.
Note: It may be necessary to move
the handle supports from side to
side in order to align the handle so
it will slide over the frame supports.
Safety
Latch
High
Pressure Hose
STEP 4: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
Pressure
Nozzle
Wand
Collar
STEP 7: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
Pump
Water Inlet
STEP 10: Check inlets filters,
remove debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
8
will result.
ASSEMBLY INSTRUCTIONS
Carriage
Bolt
STEP 2: Insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from the
inside of the machine. Tighten nuts.
Spray
Gun
Nozzle Extension
STEP 5: Attach nozzle extension
to spray gun/wand. Tighten both
by hand.
Wand
Coupler
STEP 8: Connect the high pres-
sure hose to the pump discharge
nipple. Push coupler collar forward
until secure.
Garden
Hose
8.913-995.0 • Landa PC • Rev. 03/20
Nut
Spray
Gun/Wand
Pump
Discharge
Nipple
High
Pressure
Hose
Coupler Collar
Bolts
Nut
STEP 3: Attach the spray gun/
hose storage handle and bracket to
handle. Tighten nuts.
Pressure
Nozzle
Wand
Coupler
STEP 6: Pull the spring-loaded col-
lar of the wand coupler back to insert
your choice of pressure nozzle.
Cold
Water
Source
Garden
Hose
STEP 9: Connect (7.5m) garden
hose to the cold water source.
Hose/Gun
Storage
Bracket
Studs
Advertisement
Table of Contents
