Yamaha MTN690-U Owner's Manual page 27

Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Stop/Run/Start switch " /
To crank the engine with the starter,
set this switch to " ", and then push
the switch down towards " ". See
page 5-2 for starting instructions prior
to starting the engine.
Set this switch to " " to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch "OFF/ "
Use this switch to turn on the hazard
lights (simultaneous flashing of all turn
signal lights). The hazard lights are
used in case of an emergency or to
EAU12461
"
warn other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
". When
The hazard lights can be turned on or
off only when the key is in the "ON" po-
sition. You can turn the main switch to
the "OFF" or "LOCK" position, and the
hazard lights will continue to flash. To
turn off the hazard lights, turn the main
EAU12501
switch to the "ON" position and oper-
ate the hazard switch again.
NOTICE
EAU54213
/ "
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
"TRIP/INFO" switch
This switch is used to make setting and
display changes in the multi-function
meter unit. See page 3-6 for more in-
formation.
EAU88272
To use the "TRIP" switch, move the
"TRIP/INFO" switch in direction (a). To
use the "INFO" switch, move the
"TRIP/INFO" switch in direction (b).
Instrument and control functions
1. "TRIP/INFO" switch
ECA10062
EAU78491
3-12
(a) (a) (a)
(b) (b) (b)
3
1