Yamaha MTN690-U Owner's Manual page 20

Instrument and control functions
closing of the throttle, racing,
burnouts, wheelies,
half-clutch use, etc.
ABS warning light "
3
This warning light comes on when the
vehicle is first turned on, and goes off
after starting riding. If the warning light
comes on while riding, the anti-lock
brake system may not work correctly.
WARNING
If the ABS warning light does not
turn off after reaching 10 km/h (6
mi/h), or if the warning light comes
on while riding:
 Use extra caution to avoid pos-
sible wheel lock during emer-
gency braking.
 Have a Yamaha dealer check
the vehicle as soon as possible.
Immobilizer system indicator
light " "
When the vehicle is turned off and 30
seconds have passed, the indicator
light will flash steadily to indicate the
immobilizer system is enabled. After 24
extended hours have passed, the indicator light
will stop flashing, however the immobi-
lizer system is still enabled.
EAU91850
TIP
"
When the vehicle is turned on, the light
will come on for a few seconds, and go
off. Otherwise, have a Yamaha dealer
check the vehicle.
EWA16043 Troubleshooting
If a problem is detected in the immobi-
lizer system, the light will flash in a pat-
tern. If
indicator light flashes in the pattern,
slowly 5 times then quickly 2 times, this
could be caused by transponder inter-
ference. If this occurs, try the following.
1. Make sure there are no other im-
mobilizer keys close to the main
switch. Other immobilizer system
keys may cause signal interfer-
ence and prevent the engine from
EAU91860
starting.
2. Use the code re-registering key to
start the engine.
the immobilizer system
3-5
3. If the engine starts, turn it off, and
try starting the engine with the
standard keys.
4. If one or more of the standard
keys do not start the engine, take
the vehicle and all keys to a
Yamaha dealer to have the stan-
dard keys re-registered.